ROKPRO Fork Armor

Fork armor / Dirt · Street · E-Moto

Snap on. Ride protected.

Impact-absorbing fork guards and swappable armor skins for dirt, street, and e-moto bikes.

Find your fit Shop fork guards
Four near-full-coverage RokPro fork guards installed on a dirt bike in a dark workshop

Fork armor / Ready for abuse

Why fork armor

You bought the expensive part.

Protect it with the easy part.

You don't have to obsess over your forks. RokPro gives rocks, roost, road debris, and everyday scuffs somewhere replaceable to land.

  1. 01

    Take the hit.

    Rocks, roost, and road debris meet the guard first.

  2. 02

    Keep the finish.

    Help preserve the surfaces—and the look—you already paid for.

  3. 03

    Snap on. Move on.

    Measure once. Install without tools or teardown.

Fitment, without the guesswork

Find your fit.

Measure the upper section, the lower section, or both. Each selected position matches one two-piece set—one guard for each fork tube.

01 / Choose your ride

02 / Measure one or both zones

Measure each straight fork area end to end. Select a listed length for either position, or select both for full upper-and-lower coverage.

Tools required Measuring tape only.

Between the fork crowns

Upper coverage

Optional · select a length

Below the lower crown

Lower coverage

Optional · select a length

03 / Review your setup

Dirt · Choose coverage · 0 sets Each position adds one two-piece guard set.

Shop the system

Protection outside.
Your look on top.

Start with a snap-on guard. Finish it with a swappable armor skin.

Two carbon armor skins beside a plain guard and a carbon-covered guard
Carbon-look RokPro armor skins installed over the fork guards on a blue street motorcycle
The change-up

Armor Skins

Swappable outer skins that change the finish without replacing the guard.

Shop armor skins
Need the finishing pieces? Shop accessories

How it works

Measure. Snap on. Ride.

  1. Bare hands measuring the exposed red fork zone on a full dirt bike
    01

    Measure

    Measure the straight area you want to cover and choose the matching listed length.

  2. Bare hands pressing a RokPro guard into place on a full dirt bike
    02

    Snap on

    Press the guard into position. The internal tension ribs hold it against the fork.

  3. Full dirt bike with four RokPro fork guards installed and a bare hand on the grip
    03

    Ride

    Run the guard as-is or snap on an armor skin when you want to change the look.

End-on view of an open C-shaped RokPro guard and its double-channel tension ribs

Rib Technology

Built to flex.
Built to hold.

Internal double-channel tension ribs disperse impact while holding constant pressure against the fork. The energy-absorbing polymer flexes where rigid guards can crack.

Construction
20% thicker than typical ABS guards
Material
Energy-absorbing polymer
Install
Tool-free snap-on

RokPro Fork Armor

Built for
every ride.

Find your fit